This is a three-in-one armature: It is an inlet
armature, overflow armature, and at the same
time it controls the water level – if equipped
with an additional water level sensor.
The combination armature is preferably installed
in the side pool wall below the pool edge cover.
Installation is simple, the overflow duct fits into
the muff of the channel pipe. The fresh water feed
pipe and the connection of the cable protection pipe
for the water level sensor are connected to the appro-
priate threaded nipple via PE pipe unions. The over-
flow funnel can be pushed up or pushed down 20 mm
to adjust to the water level.
Product characteristics at a glance
•
Elegant combination of freshwater inlet and pool
overflow
•
Installation possibility for water-level sensor
•
Water level can be corrected +/- 20 mm retroactively
•
Completely made of stainless steel
Overflowwall-installation combination armature
Overflow wall-installation combination armature 100 E
Dimensions
(L x W x H)
[mm]
340 x 271 x 153
For pools with liner
no
Connection
[DN/inch]
100/1
Material
Stainless steel 1.4571 (AISI 316Ti)
Weight
[kg]
6.1
Order no.
51120
Overflow wall-
installation combi-
nation armature
UWK 100 E
Damming height (mm)
Q (L/min)
Fresh
Water
Pool
Water
Sea
Water 220-240 V 400 V 110-120 V 50 Hz 60 Hz 12 V AC 24 V DC DMX DMX/
RDM
Plug and
Spray
Overflow wall-installation
241
OASE Fountain Technology / Lake Management – Catalogue
Accessories
Overflow / return armatures
